FURMAN PL-PLUSDM ENHANCED POWER CONDITIONER PLUS LIGHTS
Enhanced Power Conditioner plus lights, digital volt/ammeter, 120V/15A
The PL-PLUSD / PL-PLUSDM Power Conditioner/Light Module is the perfect accessory to any equipment rack, providing the basic power protection essential to every audio or video system. Install a PLPLUSD or PL-PLUSDM in the top slot of your rack, and the eight switched AC outlets on the rear panel will power all your equipment while its two slide-out light fixtures provide discreet, illumination of their controls on stages, in studios, or in any dark place. A dimmer control lets you adjust the lamp brightness to just the right level. The Metered Six 15 Amp Series protects your delicate electronic equipment by combining a high voltage surge and transient suppressor with an RFI/EMI interference filter. The fast-acting suppression circuit responds in nanoseconds, clamping spikes and surges to safe levels. The filter works to prevent noise from fluorescent lights, electric motors, radio transmitters, and similar sources of "electronic pollution" from leaking from the AC line into sensitive analog or digital circuits. The PL-PLUSD and PL-PLUSDM lamps come supplied with 5-watt night-light bulbs. Replacements are readily available in 4-watt sizes at most supermarkets and hardware stores. Colored Christmas tree bulbs may also be used. Bulbs are easily replaced without removing the unit from the rack by unscrewing the cap on the end of each light tube. The Metered Six 15 Amp products feature a master switch for the rear outlets. This switch glows red when the power is on. There is also a separate switch for the lamps, (PL-PLUSD and PL-PLUSDM) allowing you to check your equipment settings before applying power to it. The front-panel circuit breaker can be easily and quickly reset should any of these units be overloaded.